Skip to Main Content

DMS Equipment Quick Start Guides

Dell 1610HD

Dell 1610HD User Guide

Turning the Projector On

Step 1. Remove the lens cap.

Step 2. Connect the power cord and appropriate signal cables.

Connection ports on rear of projector; numbered 1-16

 

1  USB remote connector 9  Audio-A input connector
2  HDMI connector 10  Microphone connector

3  VGA-A output

(monitor loop-through)

 11  RS232 connector
4  VGA-A input connector 12  RJ45 connector
5  VGA-B input connector 13 Security cable slot
6  S-video connector 14  Audio output connector
7  Composite video connector

15  Audio-B left channel

input connector

8  Audio-B right channel

input connector

 16  Power cord connector

 

Step 3. Press the POWER button on the remote control to power on.

Step 4. Turn on video source (computer, DVD player, etc.).

Step 5. Change the projector input source if necessary.

Press SOURCE button on remote to change input source.

 

Adjust the projected image

Step 1. Raising or lowering the projector height

  1. Press the elevator button
  2. Raise or lower the projector to the desired display angle
  3. Release the button to lock the elevator foot into position and use the rear tilt adjustment wheels to complete display angle adjustment

Projector front with elevator button circled Projector rear with Rear Tilt Adjustment Wheels labeled

 

Step 2. Adjusting the projector zoom and focus

  1. Rotate the zoom tab to zoom in and out
  2. Rotate the focus ring until the image is clear

Projector front showing zoom and focus controls

 

Turning the Projector Off

Step 1. Press the POWER button on the remote control to power off.

"Press Power Button to Turn off Projector" message appears on screen.

Step 2. Press the POWER button on the remote control again to power off the projector.

The cooling fans continue to operate for 120 seconds.

Step 3. After the cooling fans have stopped, disconnect the power cord and signal cables.

Step 4. Replace the lens cap.