Sennheiser EW 100 G3 Wireless Set
Transmitter
Step 1. Insert 3.5mm Microphone connector into MIC/LINE input jack.
Step 2. Open the battery compartment by pressing the two buttons on the side of the transmitter and install two AA Batteries (if needed).
Step 3. Press the ON/OFF button to turn on Transmitter and close the battery compartment cover.
Step 4. Secure Transmitter by attaching to your belt with the clip or place Transmitter into your pocket.
Step 5. Use included tie clip to attach Microphone to a necktie, lapel, or other garment.
Receiver
Step 1. Open the battery compartment by pressing the two buttons on the side of the Receiver and install two AA Batteries (if needed).
Step 2. Press the ON/OFF button to turn on Receiver and close the battery compartment cover.
Step 3. Using attached mounting bracket, mount Receiver to camera shoe.
Step 4. Connect the 3.5mm audio cable from the AF OUT jack on the Receiver to the audio input jack on the camera.
Step 5. Verify that the receiver is set to the same frequency as the transmitter. If not, refer to synchronizing instructions below.
Synchronizing Receiver with the Transmitter
Step 1. Open the battery compartment of both the Transmitter and Receiver by pressing the two buttons on the side and press the ON/OFF button to turn on.
Step 2. On the Receiver, press the SET button.
Step 3. Press the arrow keys until SYNC is displayed and press the SET button.
The word SYNC will appear on the Display Panel.
Step 4. Place the Transmitter and Receiver facing each other at a distance of less than 12 inches apart.
When a check mark appears by the word SYNC, the process is successful.
Step 5. Press the arrow keys until EXIT is displayed and press the SET button.
