DMS Equipment Quick Start Guides

Dell 1410X User Guide

Turning the Projector On

Step 1. Remove the lens cap.

Step 2. Connect the power cord and appropriate signal cables.

1  VGA-B input (D-sub) connector	6  VGA-A output    (monitor loop-through)
2  VGA-A input (D-sub) connector	7  Audio output connector
3  S-video connector	8  Security cable slot
4  Composite video connector	9  Audio input connector
5  USB remote connector	10 Power cord connector

 

Step 3. Press the POWER button on the remote control to power on.

Step 4. Turn on video source (computer, DVD player, etc.).

Step 5. Change the projector input source if necessary.

Press SOURCE button on remote to change input source.

 

Adjust the projected image

Step 1. Raising or lowering the projector height

1. Adjust the projector to the desired display angle and use the front tilt adjustment wheel to fine-tune the display angle.
2. Use the rear tilt adjustment wheels to fine-tune the display angle.

 

 

Step 2. Adjusting the projector zoom and focus

1. Rotate the zoom tab to zoom in and out
2. Rotate the focus ring until the image is clear

  

 

Turning the Projector Off

Step 1. Press the POWER button on the remote control to power off.

"Press Power Button to Turn off Projector" message appears on screen.

Step 2. Press the POWER button on the remote control again to power off the projector.

The cooling fans continue to operate for 120 seconds.

Step 3. After the cooling fans have stopped, disconnect the power cord and signal cables.

Step 4. Replace the lens cap.